Forums / パーツショプMAXプロダクトフォーラム Parts Shop MAX Products Forum / Sway Bar Offset Bracket for S chassis

Parts Shop MAX :: Forums :: MAXに質問　Ask MAX :: パーツショプMAXプロダクトフォーラム Parts Shop MAX Products Forum
Sway Bar Offset Bracket for S chassis	<< Previous thread \| Next thread >>


Moderators: Parts Shop Max, Dan at MAX USA

Author

Post

Dan at MAX USA

Tue Apr 22 2014, 01:21am

Registered Member #2

Joined: Sun Jan 21 2007, 08:28pm

Posts: 2866

Sway Bar Offset Bracket S14 version

$75 for 2 brackets, bolts, washers, and tubular reinforcement (you have to specify your sway bar outer diameter)

Allows you to remove 1.5 inches / 38mm off the sway bar width for extreme angle and lowest ackerman clearance.

We are drilling the hole to 7/16" to use a 7/16" heim joint solid end link set

[ Edited Thu Oct 16 2014, 09:32pm ]

Dan at MAX USA

Thu Jun 05 2014, 12:10am

Registered Member #2

Joined: Sun Jan 21 2007, 08:28pm

Posts: 2866

S13 version is released today

Dan at MAX USA

Thu Oct 16 2014, 09:03pm

Registered Member #2

Joined: Sun Jan 21 2007, 08:28pm

Posts: 2866

We changed up the reinforcement style for the sway bar (not that there was a problem with the tubular style), however in theory this half cut tube with pointed ends gives more welding surface area and eliminates a possible focal point for stress by distributing the heat effected zone. level up.

You can see here, we have 3 different inner diameters, for different sway bar outer diameters.

The surface of the steel reinforcement is raw sand blasted steel ready to weld. **If you don't weld it & paint it right away it will rust.

It fits the bar very well if you order the correct size, so be sure to measure your sway bar DIA before placing the order online.

[ Edited Thu Oct 16 2014, 09:28pm ]


Jump: Back to top