Parts Shop MAX :: Forums :: MAXに質問 Ask MAX :: パーツショプMAXプロダクトフォーラム Parts Shop MAX Products Forum
Reinforcement sleeve for protecting the MAX rod ends when adjusted to the widest setting << Previous thread | Next thread >>
Moderators: Parts Shop Max, Dan at MAX USA
Author Post
Dan at MAX USA
Tue Dec 23 2014, 03:46AM

Registered Member #2
Joined: Sun Jan 21 2007, 08:28PM

Posts: 2866
New component debut:

Limit Break Nut

Protect your rod ends when adjusting your front lower control arms to the widest setting for angle clearance / track width, (which is 3/4" or 19mm of thread depth in rod end receiver). Covers 40mm of excessive exposed threads.

~ Gold Zinc Plated reinforcement sleeve / Jam nut
~ Upgrade for exsisting FLCA, Included in upcoming LB FLCA
~ 26mm Wrench Square
~ m22 1.5 Reverse Threaded ID matches all MAX forged rod end bearing housing threads
~ Sold in pairs for $30




[ Edited Tue Dec 23 2014, 03:47AM ]
Back to top
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System