Forums / パーツショプMAXプロダクトフォーラム Parts Shop MAX Products Forum / MAX subframe solid risers

Parts Shop MAX :: Forums :: MAXに質問　Ask MAX :: パーツショプMAXプロダクトフォーラム Parts Shop MAX Products Forum
MAX subframe solid risers	<< Previous thread \| Next thread >>

Go to page << >>
Moderators: Parts Shop Max, Dan at MAX USA

Author

Post

Dan at MAX USA

Tue Sep 27 2011, 04:14pm

Registered Member #2

Joined: Sun Jan 21 2007, 08:28pm

Posts: 2866

I don't know anyone with that dss shaft but our standard procedure is to bend the e-brake bracket

Hollywood

Tue Sep 27 2011, 07:19pm

Registered Member #708

Joined: Sun Feb 28 2010, 07:22pm

Posts: 653

we had an issue like this on kado's s14 i just did like dan said and bent the brackets up but they kept rubbing and pulling down so i just pulled the drive shaft and rivited sheet metal over the cables on the tunnel to keep themn in place and eliminated the tabs that suck and bend... make something its easy to pull the drive shaft but hard to get the correction that the risers provide lol

s0apgun

Wed Sep 28 2011, 01:32am

Registered Member #394

Joined: Sun Jul 06 2008, 02:24am

Posts: 7

You were able to rivet there? I thought part of the gas tank was on the other side of the sheet metal the clips are attached to...

Cool if not then I'll just do that

Hollywood

Wed Sep 28 2011, 08:12pm

Registered Member #708

Joined: Sun Feb 28 2010, 07:22pm

Posts: 653

yeah its in front of the gas tank iirc. not looking at it so i cant remember just remember being at thunder hill and that thing pissing me off so i just cut two strips of plumbers tape and poped them in. called it good, must be holding cuz ryans friend jullian who is on here is driving the piss out of that car now lol...